Retractable canopies for pergolas and lattice patio covers

Installation

ShadeFX Canopies Inc. is not responsible for the structural integrity of the frame the canopy mounts to. That responsibility lies with the frame constructor.

Please ensure full precautions are taken regarding the strength of the frame system to support the canopy, and for it to remain intact under negative (lifting) loads which can occur during windy conditions.

Click here to read the precautions that must be taken before beginning the installation.

  1. Remove the Drive beam from the packaging and fasten it to the underside of the pergola frame with screws provided and according to the install options shown in Fig. 2. Ensure all screws provided are fully engaged with the support beam the drive beam is being attached to.

  2. Remove the canopy assembly and fasten the fixed wing to the wall/frame with the captive screws as shown.

  3. Attach each successive canopy wing to the drive beam bearing carriers by aligning the drilled cross holes and inserting the retaining pin.

  4. Once all the wings are attached to their respective carriers, and the canopy wing tips are secured from tipping in the wind ( see installation options, Fig 2 below) the canopy is ready for trial operation. To drive the canopy, either fasten the draw cord assembly to it's appropriate post, or plug the motor power cord into a GFI protected electrical outlet.

  5. Use the draw cord, or if motorized push the remote control button, to extend the canopy fully. If motorized it will stop by itself at the factory preset limit. During movement of the canopy ensure there is no undue restriction or blockage of its free movement. Once stopped, return the canopy allowing it to stop by itself at the fully retracted position if motorized.

  6. Provided the canopy extends and retracts smoothly and is stopping at the right place when fully retracted or extended, you are now ready to enjoy the outdoor living lifestyle that ShadeFX provides.

Fig 1


Top

Fig 2


Fig 3


Top

Fig 4


Top



See it Installed

The Good News About Building Permits
Because ShadeFX is a retractable canopy, not a fixed roof, most jurisdictions do not require a building permit. So using ShadeFX gives you the utility of a large roofed area, with the convenience of sun when you want it, and the hassle free freedom to construct without a building permit.

(Check your local jurisdiction for compliance)